Snowmobile Track/Stud Tools
WOODY'S ACCESSORIES
CARBIDE GRINDING WHEELS SPECIAL GRADE GRINDING WHEEL IS DESIGNED FOR JUST SHARPENING CARBIDE RUNNERS AND STUDS. IT WILL MAINTAIN SHARP EDGES AND POINTS OR ALTER STUD POINT ANGLES. NOT RECOMENDED FOR GENERAL GRINDING. INCLUDES ARBOR SHIM
Add To Cart
TRACK TOOL
Roetin's T-nut Tool with an all new design. The tool will quickly set T-nuts without any damage to the track.
SHALLOW SOCKET TOOL
Woody's has developed a unique shallow socket for installing studs that provides the torque to tighten without touching the surface in the support plates. The 5/16" socket is deep enough to install studs up to 1.575" length. Won't scratch the backing plates.
T-NUT TOOL
With the Woody's T-nut tool, pull the T-nut in place, then hold the T-nut from the back side and remove the tool. Put a drop of 262 or 271 Locktite on the threads of the T-nut and stud. Torque the stud to 70-80 in./lb. and let dry for 24 hours at room temperature. Available in two sizes, 1/4" -20 and 7mm.
TRACTION MASTER TOOL
A new tool designed for the sharpening of all Traction Master Studs. The stud is placed inside the Master Tool and secured tightly with one turn and then chucked up to a 3/8" drill for easy and fast repetition.
TRACK DRILL TOOL CUTTER
Three sizes available. This tool cuts a neat, clean hole in the track for easy installation of all studs. Use with any 3/8" shop drill. Ejects rubber slug automatically.
SPEC GAUGE
A must for the serious racer! Designed for inspecting legal installation of studs and carbides in all competition associations.
STUD SHARPENING TOOL
Keep your steel studs sharp with this unique tool. Easy to use at home or on the track with just a few twists. Available in 30°, 45° and 60° angles.
3/8" HEX BIT SOCKET
Here is a 3/8" hex bit socket that you can use to hold the heads of Woody's and Roetin push through studs.
SQUARE SUPPORT PLATE INDEXING TOOL
A real time saver! Attach the tool directly to a standard 3/8" ratchet: align the support plate flush with the track lugs and then tighten the nut. Aligning the support plates can contribute to track longevity and your safety. The indexing tool is available for both 7mm and 5.16 square support plates.
